Wilo pump installation project
Sold 0
Refunds 0
Good feedbacks 0
Bad feedbacks 0
Detailed design for the installation of a Wilo pump type Atmos GIGA-N 80/200-55/2.
The pump is installed on a concrete base to replace the existing one.
The frequency converter (VFD) is connected to two pumping units with the help of two additionally installed knife switches.
To protect the pump motor, a monitoring and protection device of the MD-4M motor type is installed.
Drawings of the ES section for the installation ON Wilo:
- Common data.
- Electrical single-line diagram before reconstruction.
- Schematic diagram of a single-line power supply for the CH-1 electric drive.
- Technological scheme of the thermal pumping station.
- Schematic diagram of CH-1 control circuits.
- Layout plan of equipment and pipelines.
- Sketch of the installation of the pumping unit.
- Specification of equipment, products and materials.
Format - DWG compatible with AutoCAD 2004-2017, Compass, ZWCAD, nanoCAD, BricsCAD, etc.
The pump is installed on a concrete base to replace the existing one.
The frequency converter (VFD) is connected to two pumping units with the help of two additionally installed knife switches.
To protect the pump motor, a monitoring and protection device of the MD-4M motor type is installed.
Drawings of the ES section for the installation ON Wilo:
- Common data.
- Electrical single-line diagram before reconstruction.
- Schematic diagram of a single-line power supply for the CH-1 electric drive.
- Technological scheme of the thermal pumping station.
- Schematic diagram of CH-1 control circuits.
- Layout plan of equipment and pipelines.
- Sketch of the installation of the pumping unit.
- Specification of equipment, products and materials.
Format - DWG compatible with AutoCAD 2004-2017, Compass, ZWCAD, nanoCAD, BricsCAD, etc.