Video course - Electronic Control Unit (ECU) repair
If the total amount of your purchases from the seller CarHelper more than:
- 862 ₽ the discount is 30%
Sold 1
Refunds 0
Good feedbacks 0
Bad feedbacks 0
The proposed film will be discussed is about it. They will highlight issues of bundling workplace repairman equipment and tools, the architecture of the modern computer, given the logic block and search techniques defect using an oscilloscope, tester and a laboratory power supply.
Separate we will talk about the methods of soldering. The fact that the replacement of a component should possess repairman techniques mounting and dismounting of elements by means of solder and soldering station. The film shows two methods of replacing the processors of different types of control keys ignition coils, device drivers, as well as removing the ROM chip from a block M1.5.4, which must be done at the chip-tuning of the ECU.
In short, the film contains virtually all the information necessary for the organization of the workplace and of the most common types of computer repair at a service station.
Separate we will talk about the methods of soldering. The fact that the replacement of a component should possess repairman techniques mounting and dismounting of elements by means of solder and soldering station. The film shows two methods of replacing the processors of different types of control keys ignition coils, device drivers, as well as removing the ROM chip from a block M1.5.4, which must be done at the chip-tuning of the ECU.
In short, the film contains virtually all the information necessary for the organization of the workplace and of the most common types of computer repair at a service station.
Time of the video more than 2 hours