Development
Sold 1
Refunds 0
Good feedbacks 0
Bad feedbacks 0
Sometimes, in the manufacturing process it is necessary to bend the tube at an angle 90. If the pipe diameter 20 - 50 mm, then there is no problem, but if the diameter of 200 - 500 mm or more?
Just for this task and designed this program. It builds a scan element of the pipe bend. Then you just have to print and give it the unfolding cutter.
In order to build the unfolding plot you do not have it in the program. To build you only need to enter the radius, the length of the circumference of the pipe and the auxiliary angle (usually taken 22.5 degrees). Then you can see the resulting building in the preview and print.
Just for this task and designed this program. It builds a scan element of the pipe bend. Then you just have to print and give it the unfolding cutter.
In order to build the unfolding plot you do not have it in the program. To build you only need to enter the radius, the length of the circumference of the pipe and the auxiliary angle (usually taken 22.5 degrees). Then you can see the resulting building in the preview and print.